Tom Reay
Pro
Central California USA Rep
Posts: 74
|
Post by Tom Reay on Oct 19, 2011 20:33:47 GMT -8
Does anyone make the seal that goes against the body around the side and pop out windows?
|
|
|
Post by Franck Boutier on Oct 20, 2011 5:29:53 GMT -8
Hello Tom , Do you have a picture to explain what you're talking about, please ? Thank you ! Franck.
|
|
|
Post by Lee Hedges on Oct 20, 2011 16:15:11 GMT -8
Is that the roof-to-body seal (thin U-shaped) that mounts under the long aluminum trim pieces? It goes under the quarter window & A-pillar trims also.
|
|
Tom Reay
Pro
Central California USA Rep
Posts: 74
|
Post by Tom Reay on Oct 20, 2011 17:47:25 GMT -8
Is that the roof-to-body seal (thin U-shaped) that mounts under the long aluminum trim pieces? It goes under the quarter window & A-pillar trims also. It is, and i just saw that Rudiger has them for 48E a set. I'll have to think about that....
|
|
|
Post by Franck Boutier on Oct 21, 2011 4:00:54 GMT -8
Ok Tom , I bought this seal from Rudiger and installed it a short time ago and it fits very well !
Franck.
|
|
|
Post by Brad Bull on Oct 21, 2011 7:15:41 GMT -8
So it's these. Doesn't seem like that bad a deal for a full set.
|
|
|
Post by Wally Burrows on Oct 21, 2011 12:57:02 GMT -8
I purchased this seal from Rudiger as well. It came in a roll as one piece. Is there enough to do both sides? I would like to know if I should consider ordering another to be sure I have enough.
|
|
|
Post by Lee Hedges on Oct 21, 2011 15:10:26 GMT -8
Has anyone within the USA ordered the KGP&R (T14) version of this seal? I recall (long ago) that the T14 width was different (thinner) than the T34 width. The KGP&R seal (if it works) should be a lot less expensive than the Rudiger Huber one from Germany.
|
|
|
Post by bobnotch on Oct 25, 2011 12:15:15 GMT -8
Has anyone within the USA ordered the KGP&R (T14) version of this seal? I recall (long ago) that the T14 width was different (thinner) than the T34 width. The KGP&R seal (if it works) should be a lot less expensive than the Rudiger Huber one from Germany. Yes. I did. I talked to Scott (I think), and told him I was working on a T-34. He recommended a slightly different part number, which is the longer version of that seal. It's actually long enough to start at the front edge of the door, go up and around the windows, and then cover the area under the 1/4 window. I had to buy 2 of these (it worked out to 2 pairs of their regular seals, but NOT cut in half like they normally would). The quality is good, and it fit just like the OE seal did. Tom, it might be worth it to give them a call. I started out with their published part number (off their website), and just told them I've got a T-34. He went out of his way to get me what I wanted.
|
|
Tom Reay
Pro
Central California USA Rep
Posts: 74
|
Post by Tom Reay on Oct 25, 2011 20:46:19 GMT -8
I ended up going after my original ones with steel wool and a razor, and they came out looking really good.
|
|